Calibre Mecca 25mm Footrest Corner Grab Rail 215mm Chrome - NRCR2508WCH

• Foot rest or corner grab rail 215mm
• Material: Stainless steel
• Australian Owned and Designed
• The corner rail can be mounted at the waist height as a grab rail or lower as a foot rest
• Available in over 7 finished including Living Brass, Chrome, Matt Black, Gunmetal, Brushed Nickel, Bronze, Gold
• Modular design, the rail to be cut down to suit your bathroom
• 150 kg capacity for all 25mm diameter calibre grab rails
• Calibre Mecca 25mm diameter rails are suitable for private homes, assisted living and bathrooms where full AS1428.1 compliance is not required
• A stylish design to help prevent falls in the bathroom and live independently
• Minimalist design complements modern bathroom accessories

Installation Instruction:

1. Locate wall studs, install into at least one stud.
Place wall seal/mounting bracket on wall at correct height over centre of stud and mark hole positions on wall.

2. Drill pilot holes into wall stud approximately 60mm deep to suit mounting screws (and wall plugs if required).
Tip:4mm hole for screws into timber or 10mm hole for wall plugs.

3. Apply small amount of silicon to mounting bracket and wall in and around the screw holes.

4. Install mounting brackets by screwing onto wall.
Tip: Use appropriate mounting screws for the wall stud material, supplied screws are for timber wall studs.

5. Push corner rail onto wall brackets.
Tip: Rail length can be cut down to a smaller size, simply use an angle grinder, hacksaw or pipe cutter then deburr the end with a file or grinder and reinsert into the end bracket.

6. Tighten grub screws with allen key.
Tip: If rail rattles, loosen end bracket, twist slightly and tighten.

7. Finished.