Mecca Care Shower Mixer Chrome - NR221911XCH

• Extended Lever Wall Mixer
• Suitable for accessible bathrooms where extra leverage is required
• Material: Brass
• Watermark Licence: WM-060073
• Temperature Rating: Min 1℃ - Max 75℃
• Pressure Rating: Min 150KPa - Max 500KPa
• 35mm ceramic cartridge can be adjusted to control water temperature and flow control setting, saving energy
• Metal wall plate construction for longevity
• Body inlets – ½ BSP female
• Suitable for mains pressure installation
• Replaceable trim kits
• Packed Separately (Body and Trim Kits)
• Comply to AS1428.1 2009 AMDT 1 design for access and mobility requirements

Install Advice:

Installation Instruction for Body Only:

GENERAL INSTRUCTIONS:

- This product must be installed by a licensed plumber. Ensure that your plumbing installation conforms to the Australian/New Zealand Standard AS/NZS 3500.
- All pipework must be thoroughly flushed prior to the installation of the mixer. In-line filters must be fitted on both hot and cold supplies to prevent foreign particles from damaging the ceramic cartridge.
- All outlets used primarily for personal hygiene must deliver water at a safe temperature in accordance with regional regulations.

1. Secure the mixer body (1) to the nogging, ensuring an installation depth of 51-68mm from the nogging to the ceramic tile. Note: Do not remove the plastic sleeve (2) from the mixer body.

2. Connect the cold and hot water supply lines and
perform a leak test.

3. Drill a φ50mm hole in the plasterboard for mixer
body installation, and then position the plasterboard.

4. Mark the plastic sleeve (2) 4-7mm from the ceramic tile surface to the body and waterproof the gap between the plasterboard and body.

5. Remove the self-tapping screw, washer, and plastic
sleeve, then cut the sleeve at the marked point.

6. Reattach the self-tapping screw, washer, and plastic sleeve.

Installation Instruction for Trim Kits Only:

1. Drill a Ø50mm hole in the ceramic tile, then position.

2. Undo the self-tapping screw, washer, plastic sleeve.

3. Insert the O ring to the dressing bell groove, and slide the dressing bell onto cartridge.

4. Apply waterproof treatment to the area.

5. Tighten the dressing ring on the dressing bell.

6. Slide the backplate onto the wall.

7. Attach the washer to the cartridge rod, position the handle, tighten it with a grub screw using an Allen key, and cap the grub screw hole.