- This option allows you to switch between overhead or hand shower heads
- Material: Brass
- 35mm ceramic cartridge can be adjusted to control water temperature and flow control setting, saving energy
- Shower mixer with quarter turn divertor defaults to bath spout/shower
- Metal wall plate construction for longevity
- Body inlets – ½ BSP female
- Suitable for mains pressure installation
- Wels rating not required
- Replaceable trim kits
- Packed Separately (Body and Trim Kits)
Install Advice:
GENERAL INSTRUCTIONS:
- This product must be installed by a licensed plumber. Ensure that your plumbing installation conforms to the Australian/New Zealand Standard AS/NZS 3500.
- All pipework must be thoroughly flushed prior to the installation of the mixer. In-line filters must be fitted on both hot and cold supplies to prevent foreign particles from damaging the ceramic cartridge.
- All outlets used primarily for personal hygiene must deliver water at a safe temperature in accordance with regional regulations.
Installation Instruction for Body Only:
1. Secure the mixer body (1) to the nogging, ensuring an installation depth is 68-78mm from the nogging to
ceramic tile.
Caution: Do not remove plastic sleeve (2) from the mixer body.
2. Connect the cold and hot water supply lines and
perform a leak test.
3. Drill a φ50mm and a φ40mm hole in the plasterboard for mixer body, and then position plasterboard.
4. When the installation depth is 68-70mm, make the
plastic sleeve (2) 2-4mm from ceramic tile surface to body. when the installation depth is 71-78mm,make the plastic sleeve (2) 4-7mm from ceramic tile surface
to body. Then waterproof the gap between the plasterboard and body.
5. Remove self-tapping screw, washer and plastic
sleeve, and cut the plastic sleeve from the marked
point.
6. Reattach self-tapping screw, washer and plastic
sleeve.
7. Waterproof for the gap the plasterboard and body.
Installation Instruction for Trim Kits Only:
1. Drill a Ø50mm and a Ø30mm hole in the ceramic tile, then position it.
2. Undo the self-tapping screw to remove the plastic sleeve.
3. Insert the O ring to the dressing bell groove, and slide the cartridge bell onto cartridge and slide divertor dressing bell onto divertor cartridge.
4. Apply waterproof treatment to the area.
5. Tighten up the dressing ring on the cartridge bell.
6. Slide the backplate onto body.
7. Attach the washer to cartridge rod, position the handle, tighten it with a grub screw using an Allen key, and cap the grub screw hole.
8. Put knob onto divertor cartridge, tighten it with
grub screw using Allen key, and cap the grub screw hole.
