York Freestanding Bath Set With Metal Hand Shower Chrome - NR692103a02CH

• Ceramic disc valves
• Telephone style hand shower
• Floor standing pipes with small adjustment
• Brass Construction for durability
• WELS Rating: 3 Star, 9L/Min
• Wels Reg No. S18040
• Material: Brass
• More options available, see Avail or Nero’s website

Install Advice:

Installation Instruction:

GENERAL INSTRUCTIONS:
- This product must be installed by a licensed plumber. Ensure that your plumbing installation conforms to the Australian/New Zealand Standard AS/NZS 3500.
- All pipework must be thoroughly flushed prior to the installation of the mixer. In-line filters must be fitted on both hot and cold supplies to prevent foreign particles from damaging the ceramic cartridge.
- All outlets used primarily for personal hygiene must deliver water at a safe temperature in accordance with regional regulations.

- The main body is already factory-tested and adjusted, so do not disassemble it to avoid affecting performance.
- Before installing the free standing bath set, be sure to clean out any impurities and sludge from the pre-installed water pipes to prevent clogging.
- After installation, check all connections for tightness to ensure there are no leaks.
- For piping, the left side is for hot water inlet and the right side is for cold water inlet. Do not reverse them.
- The normal operating water pressure is 150kpa - 500kpa.
- Recommended water temperature for use is 4°to 55°C.

1. Apply thread sealant or Teflon tape
The apex of Hot & Cold outlets are positioned2-5mm below tile surface.

2. -Prior to commencing installation, verify that the distance between the hot and cold water outlets is 150mm. Confirming that the apex of these outlets is positioned 2- 5mm below the tile surface for optimal
fitting.
- Apply thread sealant or Teflon tape onto G1/2 water outlets.
- Place the adapter onto the outlets. Accurately locate the positioning studs, then drill pilot holes at these points. Securely install the adapter using dynabolts, ensuring a firm and stable connection

3. - Flush the internal piping prior to installing the bath set.
- Install the cover plate at the bottom, and then secure the bath set to the floor with dynabolts , ensuring the
stability of the bath set's base.
- Test and check for leaks.

4. - Connect the hand shower to the top of the bath set body.
- Ensure that the hose is connected properly and check the hose for any kinks or twists that might restrict water flow.
- After securing, test the hand shower to ensure it operates correctly.
- Test and check for leaks.