Calibre Mecca 32mm Ambulant 90 Degree Bent Tube Grab Rail 450x450mm Brushed Bronze - NRCR3290DBZ

• 450mm in each direction
• AS1428.1 Approved for Ambulant Toilets
• Material: Stainless steel
• Australian Owned and Designed
• Can be mounted on left or right hand side
• Optional add on toilet roll holder attaches to the 32mm rail
• Available in over 7 finishes including Living Brass, Chrome, Matt Black, Gunmetal, Brushed Nickel, Bronze, Gold
• Modular design, the rail to be mounted horizontally, vertically or at any angle and cut down to suit your bathroom
• 150 kg capacity for all 32mm diameter calibre grab rails
• Mod 32mm diameter rails are approved for standard AS1428.1 requirements in DDA bathrooms
• Can be used by the toilet or in the shower to help get on and off the toilet or from a shower seat

Installation Instruction:

1. Locate wall studs, install into at least one stud.
Place wall seal/mounting bracket on wall at correct height over centre of stud and mark hole positions on wall refer left picture. (minimum 2 supplied screws per bracket).
Tip: Rail height is 790mm above the ground.

2. Drill pilot holes into wall stud approximately 60mm deep to suit mounting screws (and wall plugs if required).
Tip:3mm hole for screws into timber or 8mm hole for wall plugs.

3. Apply small amount of silicon to mounting brackets and wall in and around the screw holes.

4. Install mounting brackets by screwing onto wall.
Tip: Use appropriate mounting screws for the wall stud material, supplied screws are for timber wall studs.

5. Disassemble parts firstly.
(a)Make a marker at 390mm of rail, slide the 32mm ring onto the marker of rial tubes and tighten the M4 screw by allen key.
(b)Fix the 16mm rod to the ring with M4 screw.
(c)Install the 25mm rial onto 16mm rod by screw

6. Slide rail tubes into end brackets and push onto wall brackets.
Tip: Rail length can be cut down to a smaller size, simply use an angle grinder, hacksaw or pipe cutter then deburr the end with a file or grinder and reinsert into the end bracket.

7. Tighten grub screws with allen key.
Tip: If rail rattles, loosen end bracket, twist slightly and tighten.

8. Finished.
Tip: Optional add on toilet roll holder attaches to the 25mm rail.